ABB ACQ580-04-585A-4 Instrucciones De Instalacion Y Puesta En Marcha página 16

16 EN – Quick installation and start-up instructions
Before you activate the automatic fault reset or automatic restart functions
of the drive control program, make sure that no dangerous situations can
occur. These functions reset the drive automatically and continue operation
after a fault or supply break. If these functions are activated, the installation
must be clearly marked as defined in IEC/EN/UL 61800-5-1, subclause 6.5.3,
for example, "THIS MACHINE STARTS AUTOMATICALLY".
Use the control panel to do the start-up procedure. The two commands at the bottom
of the display (Options and Menu) show the functions of the two softkeys
located below the display. The commands assigned to the softkeys are different
depending on the context. Use the arrow keys , ,
EN
change values depending on the active view. The key
page.
DE
1.
ES
Power up the drive. Make sure
that you have the motor name-
FR
plate data available.
Select the language you want to
IT
use and press
Note: After you select the lan-
TR
guage, it takes a few minutes for
the control panel to wake up.
4.
The Home view monitors the val-
ues of selected signals.
Motor overload protection
￭
Motor overload protection is not enabled by default. Motor overload protection can
be measured or estimated in one of the following ways: 1) using motor temperature
devices, 2) using a motor model defined by parameters, or 3) using motor current and
2.
Select Start set-up and press
(OK).
(OK).
5.
Make additional adjustments
starting from the Main menu.
Press (Menu) in the Home
view to enter the Main menu, and
select Primary settings and press
(Select).
and to move the cursor or
?
shows a context-sensitive help
3.
To complete the First start assist-
ant, select the values and settings
when prompted by the assistant.
Continue until the panel shows
that the first start is complete.
When the panel shows that the
first start is complete, the drive
is ready for use. Press
to enter the Home view.
6.
To get more information on the
Primary settings menu items,
?
press to open the help page.
and
(Done)