GE AWCS08 Manual De Instrucciones página 5

Controls
Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
1 2
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the Set temperature.
2. Display
Shows the Set temperature or time remaining on the
Delay timer. Shows the Set temperature while setting
the temperature in Cool or Eco modes.
3. Temp and Delay Increase + /Decrease – Pads
Use to set temperature or delay time. Temperature can
be set in Cool and Eco mode.
4. Mode Pad
Use to set the air conditioner to Fan Only, Cool, or
Eco mode.
5. Fan Speed Pad
In Cool or Eco mode: Use to set the fan speed to
Auto, High, Med or Low on the unit.
In Fan Only mode: Use to set the fan speed to High,
Med, or Low on the unit.
6. Delay Pad
(set by remote control only)
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can be
set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay pad on the remote control. Each
touch of the Increase
remote control will set the timer in 1-hour intervals.
To review the remaining time on the Delay timer, press
the Delay pad on the remote control. Use the Increase
+ –
/ Decrease pads on the remote control to set a
new time if desired.
To cancel the timer, press Decrease
remote control until the set time is --.
49-5000858 Rev. 0
3 4
Mode Cool Fan Eco
Speed Auto Low Med High
5
+ –
/ Decrease
pads on the
–
pad on the
8 7
Filter Sleep
WiFi
9
Solid light indicates WiFi
connected
Blinking light indicates
connecting
See Appliance Communication
section in this manual
7. Sleep Pad
(set by air conditioner controls only)
The SLEEP mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
The SLEEP mode is available only in COOL and
FAN only settings.
Press the SLEEP mode pad and its light will
illuminate. The fan indicator will stay at the same
setting but the air conditioner will automatically
change the FAN speed to low in either COOL or
FAN only mode.
In FAN only mode, the fan will stay in the LOW
speed setting for 8 hours. After 8 hours, the air
conditioner will turn off
In COOL mode, the fan will stay in the LOW speed
setting for 8 hours from the time the SLEEP mode
pad was pressed. The air conditioner will also raise
the set point 2°F in 30 minutes and 2°F more in
another 30 minutes where it will remain for the next
7 hours. After 8 hours, the air conditioner will turn
off.
While the unit is in SLEEP mode, pressing any pad
(except WIFI pad), the unit will exit SLEEP mode.
8. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
250 hours of operation. Clean the air filter (refer to
page 7), place it back in the front panel, and press the
Filter Reset pad. The light will go off.
9. WiFi Connect Pad
Enables connection of the air conditioner to the
home WiFi. Download App for details at:
www.GEAppliances.com/connect.
1
Power
5
Speed
3
4
Mode
6
Eco Delay
Remote Control
5