Publicidad
Idiomas disponibles
Idiomas disponibles
1. Turn on Power at Breaker
If LCD screen flashes and beeps continuously, the wiring is in=
correctly installed. Verify that wiring in house is correctly in=
stalled. If so, call Bosch Service.
2o Test
Rangetop
Burners
Test Burner
Ignition,
Select a rangetop burner knob. Push
down and turn to the flame symbol. The ignitor/spark
module
will produce a clicking sound. Once the air has been purged from
the supply lines, the burner should light within four (4) seconds.
Test Flame: High Se_:ing,
Turn burner on to HL See figure 6
for appropriate flame characteristics.
If any of the burners continue to burn mostly or completely yeF
low, call Bosch Service.
Test Flame:
Low Setting,
Turn burner on to LO. Verify that
the flame completely surrounds the burner. There should be a
flame at each burner port and there should be no air gap be-
tween the flame and the burner. If any of the burners do not
carry over, call Bosch service.
Test the ignition
and _ame of each rangetep burner
as
described
above,
Figure
6
Flame
Characteristics
Yellow FJames:
Further adjustment is required.
Yellow Tips on Outer Cones:
Normal for LP Gas.
Soft Blue Flames:
Normal for Natural Gas.
If the flame is completely
or mostly yellow, verify that the regulator
is set
for the correct fuel.
After adjustment,
retest.
Some
yellow
streaking
is normal
during
the initial
startoup.
AHow unit
to operate
4o5 minutes
and reoevaUuate
before
_aking
adjustmentso
__
.__j
Call BOSChSerWce (80B19_:2904)if:
h
1: Any of the burrJers de not light'
q
2'
The broi! burner
or bake burner flame goes
out before
it reaches 3SO o F.
' of the burners
continue
to burn ye|moW,_
if burner/flame
adjustment is required, proceed to"Step 6:
Adjust Flame (if necessary)", next page. Otherwise, installa-
tion is complete at this point.
3,
Test Oven
Burners
Remove the oven boL_em cover. Remove the two rear thumb
screws, slide cover forward and out.
Test Bake Burner
Ignition.
Set the oven to bake at 350 ° R
After 30=75 seconds, the burner will ignite. The burner will stay
lit until the 350 ° F is reached and then shut off. From this point
forward, the burner will cycle on and off to maintain the tem-
perature.
Test Bake Burner
Flame.
While the burner is lit, inspect the
flame.
See Figure 6 for proper flame characteristics.
If the
flame burns completely or mostly yellow, adjust the bake burner
air shutter. See Figure 8 (next page) for details.
Test Broil Burner Ignition.
Set cooking mode to Hi Broil. The
burner will ignite after 30=75 seconds.
Test Broil Burner
Flame.
While the burner is lit, inspect the
flame.
See Figure 6 for proper flame characteristics.
If the
flame burns completely or mostly yellow, adjust the broil burner
air shutter. See Figure 7 (next page) for details.
Replace oven bottom
cover.
Slide cover into place and re=
place two rear thumb screws.
Page 6
Publicidad
