Publicidad
Idiomas disponibles
Idiomas disponibles
Dry Storage Mode:
To deactivate the cooling to one of the zones follow the steps below:
LEFT Zone:
Press and hold the + and SET buttons at the same time. The display will show (- - -)
to confirm the zone has been deactivated.
RIGHT Zone:
Press and hold the - and SET buttons at the same time. The display will show (- - -) to
confirm the zone has been deactivated.
To turn the cooling system back on to the deactivated zone, please repeat the steps above. The system
will return to normal cooling process.
USB Connector: Output +5V DC/1A is suitable for temporary connection of small devices like mobile
phones, tablets etc.
System Reset:
To reset the unit to the factory default, turn off the unit by pressing the POWER
ON/OFF button, press and hold the SET button until the message E1 is shown in the display window.
Press the + and – buttons at the same time until the screen resets.
Battery Protection Mode:
While in normal running mode, press and hold the SET button until the screen flashes to enter the
Battery Protection Setting.
Press the SET button again to select the required protection setting
H
High
This setting should be used when connected to car power source.
M
Medium
This setting should be used when using a portable battery or other back-up
battery source
L
Low
This setting should be used when using a portable battery or other back-up
battery source
The Battery Protection Mode should be set to H to M or from M to L if there is a voltage protection error
F1 shown on the display panel. The mode should be set to H if the unit keeps working after turning off
the car engine as the product could drain the car battery.
Voltage Reference:
INPUT
MODE
L
M
H
Interior Lighting
This unit is equipped with an interior LED light located inside the compartment.
Your unit can also serve as storage bin.
DC 12V
CUT OUT
CUTIN
9.0V
1 0.9V
10.lV
11.4V
11.lV
12.4V
DC 24V
CUTIN
CUT OUT
22.7V
21.3V
22.3V
23.7V
24.3V
25.7V
10
Publicidad
