Publicidad
Idiomas disponibles
Idiomas disponibles
Always disconnect fuel and battery before making adjustments or before attempting any
part assembly or disassembly.
The contact arm and nose will become hot after prolonged or rapid use. DO NOT TOUCH
with BARE HANDS, allow to cool or use gloves when adjusting a tool that is hot.
The no-mar tips are used to prevent scratches to the work surface. Use the following steps to install the no-
mar tip to the contact arm:
1. Remove the fuel cell and battery from the tool.
2. Remove no-mar tip from storage compartment located on the reverse side of the magazine. (Fig. 6 &7)
3. Install no-mar tip on contact arm, note markings to indicate the exit location of the nail to help with proper
positioning. (Fig. 4 & 5)
4. When not in use, no-mar tip can be returned to storage location.
4
No-Mar Tip
2
6
No-Mar Tip
Before attaching or removing the nose cap, be sure to take your finger off the trigger and
remove the fuel cell and battery.
NOTE:
• Keep the nose cap on when driving nails into slippery materials such as thin steel sheets.
• Remove the nose cap when driving nails into wood.
REMOVING/ATTACHING THE NOSE CAP
The nose cap is attached simply by pressing it onto the Push Lever. To remove, insert a screwdriver or
similar into the gap between the nose cap and the contact arm and pry off.
Contact Arm
Nose cap
USING THE NON-MARRING FINISH TIPS
Contact Arm
Magazine
HOW TO USE THE GCN40T NOSE CAP
5
Contact Arm
No-Mar Tip
7
No-Mar
Tip
Magazine
Screw Driver
-17-
Contact Arm
Nose cap
Publicidad
