American Standard Colony Pro 7075100 Manual Del Propietário página 3

INSTALLATION INSTRUCTIONS
1
INSTALL FAUCET
Turn off hot and cold water
supplies before beginning.
• Seat SEAL (2) into under side of FAUCET BODY (1).
• Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN ASSEMBLY (8) through the mounting
hole of lavatory. Figure A.
• From below, push GASKET (7) and RETAINING WASHER (5) onto MOUNTING STUD (4). Secure Faucet
with MOUNTING NUT (6), pulling faucet to front of sink, so SUPPLIES (3) rests against mounting hole.
Before final tightening, make sure collar on MOUNTING NUT (6) is seated into RETAINING WASHER (5).
• Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6) to complete faucet mounting.
COLLAR ON
MOUNTING NUT
7
5
6
MOUNTING
SURFACE
4
Figure B
Figure A
4
(OPTIONAL
DECK PLATE)
2000102P-YYY
1
2
3
5
8