American Standard Colony Pro 7075100 Manual Del Propietário página 5

4
MAKE WATER SUPPLY AND WASTE CONNECTIONS
• Connect FLEXIBLE SUPPLIES (1, 2) directly to
wall supplies. Connection on fitting supplies are
3/8" compression. Connect left SUPPLY (1) to
Hot (Marked with a Red Band) and right supply
to COLD (2) wall supply.
• Faucet supplies are 20" long from faucet base.
Note: If additional supply length is
required, installer must purchase
additional parts separately.
Important: If SUPPLY HOSES (1, 2) are to
long, loop as illustrated to avoid kinking.
5
TEST INSTALLED FITTING
• With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
• Remove AERATOR (3).
• Operate HANDLE (1) to flush water lines thoroughly.
• Replace AERATOR (3).
CHECK DRAIN CONNECTIONS
• Operate POP-UP KNOB (4) and fill lavatory with
water. Check that DRAIN STOPPER (5) makes a
good seal and retains water in Sink.
• Release POP-UP KNOB (4) down and check all
drain connections and "P" trap for leaks.
Tighten if necessary.
APPROX. 20"
1
RED
BAND
HOT
ON
4
WASTE
OUTLET
2
"P" TRAP
2
BLUE
BAND
3/8" COMPRESSION
COLD
OFF
1
COLD
HOT
3
2