Dynamic Junior DMX225 Instrucciones De Utilización Y Mantenimiento página 10

User guide Junior DMX
EN
Never use accessories not recommended by
the manufacturer. They may be a hazard for
the user and may damage the device. Only
use original items and accessories.
CARE
The appliance can be cleaned using a sponge
or a slightly damp cloth.
To clean the inside of the bell, run the
appliance with the tube and its bell in clean
water for 3 seconds.
Clean the stand in clean water using washing
up liquid if necessary.
Be carreful : risk of cuts when clea-
ning the mixer attachment equip-
ped with the blade.
NEVER clean the appliance using a hose.
NEVER immerse the motor block in liquid.
MAINTENANCE
It is preferable to regularly check:
- That the power cable is in good condition
(the copper wires in the cable should not
be visible).
- That the tube is watertight (by visually
inspecting the seal condition after having
removed the blades).
10
- That the blades are sharp.
If the power cable is damaged, it must be
replaced by the manufacturer, its after-selfs
service or people of similar qualification to
avoid danger.
ELECTRIC REQUIREMENTS
The mixer of a class 2 category (double
insulation) powered by a single phase alter-
nating current and does not require a "u"
ground plug.
The installation must be protected by a
ground fault circuit breaker and a 10 A
calibre fuse.
Use a standard 10/16 A single phased soc-
ket.
Check that the electricity supply voltage and
the value on the mixer specifications plate
are compatible.
ELECTRICAL DIAGRAM
S1
N
L
CERTIFICATE OF CONFORMITY
CUSTOMER SERVICE AND
WARRANTY
This machine is in accordance with CE stan-
dards and :
0.1 uf
Variator
Motor
Moteur