Before
Puttin 9 Into use
,..,
• Before connecting the.appliance
to.electrical.power
;-
f thegasket
is damage d or the-door seal is
poor,_energy consumption i s substantlal!y
supply: eave it stand for about 2 hours which will
reduce the po'ssibility of maffur;ctions in the cooling"
system due to transport handt_ng
• Clean the appliance thoroughly, especially in the
interior (See Claaning and Maintenance)
• In case the interior accessones are not correctly
placed, rearrange them as described in chapter
"Description of the Appliance"
higher To restore efficiency, ;eplace
the gasket.
• Al,,_ays'consider;instructibns
sia-te_ in ' _-
sectloh.s Po'sthenir_g and Energy:Saving
Tips, otherwise the energy cens;Jmption is
substantially higher.
Instructions
for Use
These instructions for USe are intended for the user
They describe the'appliance
and correct operating
procedures for safe use
SAVE THESE
INSTRUCTIONS:
• Our products use environmentally
ffiendty manner.
To this end,'indivldual
packaging materials are
clearly marked.
• These Instructions are-printed either on recycled
paper or chlorine free bleached paper
• When your appliance finally wears out, please try
not to burden the environment with it; call your
nearest authorized service agent. (See Dlspostng
,
,
,
,
.
,,
,
-
of Worn Out Appliance)
- - :
.......
• Try not to open the'doer tad often, especially whe'n
the weather is hot a'nd humid. Once you open the -.
door, close it as soon as possible, This ]s espedafly
important if yoti have an upright model.:_ L, -"_':-'.2
• Every n6w and then check if the appttadoe,is - : _':;
sufficiently ventilated (adequate air clrc_]atfdn_ _. '"
behind _he app]lance),
.
; .......
. =:. " _.-
• Set the thermoslat from higher to lower settings as
soon as possible (depends on how loaded the
appliance fs, ambient temperatures etc)
• Before loading the appliance w]th packages of fresh
foods, make sure that they are cooled to
ambient temperature
(excluding soups)
• Ice and frost layers increase energy consumption,
so clean the appliance as soon as the frost layer
is 3-5 mm thick.