Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE INSTALLING YOUR TOILET
please see your product spec page to verify the dimensions and water supply
connections. Visit our website where you can search by Model number for the
product spec page at: http://www.americanstandard-us.com
IF REMOVING AN EXISTING TOILET
1
Turn off water
supply
INSTALLATION INSTRUCTIONS
BACK-TO-BACK INSTALLATION
Depending upon your plumbing and venting conditions, the flow from this toilet in a back-
to-back installation may create a vacuum on the system and draw water from the opposing
bowl. The National Standards Plumbing Code prohibits the use of a cross fitting for drainage
as throw over is possible. The code does approve a directional "Y" style fitting with proper
venting to direct the water downward and away from the other toilet.
7302484-100 Rev. E (6/23)
2
Flush to remove water from
tank; sponge remaining water
from bowl before removing toilet
Recommended fitting type for
back-to-back installations.
3
Clean flange
CAUTION
If leaving floor flange open
for more than 1-2 hours,
cover flange to prevent
escaping sewer gasses.
Publicidad
