Publicidad
Idiomas disponibles
Idiomas disponibles
Rear Panel Connections
1. SYSTEM GROUND TERMINAL
To reduce hum to a minimum, this terminal is used to interconnect the chassis or ground lead of the Turn-
table to this Amplifier. Attach the ground lead from your Turntable to this terminal. To further minimize hum,
it may be necessary to connect the GROUND terminal with a wire to the nearest water pipe which goes directly
to true ground.
2. PHONO INPUT JACKS
Input for turntable with a magnetic or variable-reluctance cartridge having 47,000 ohms of load impedance.
Connect shielded cables from your phono arm to the LEFT and RIGHT input jacks. To avoid loss of high
frequency response, it is recommended that these cables not exceed 6 feet in length.
NOTE:
Do not place your turntable on a speaker enclosure. This will avoid howling caused by transmitting
of the speaker vibration to the turntable.
3. CD INPUT JACKS
Connect the output cables of the compact disc player to these jacks marked CD, matching the L (left) and
R (right).
4. TUNER INPUT JACKS
Input for connection of your matching Tuner. You will have leads from the Tuner to connect to this Ampli-
fier. One lead will carry the LEFT channel information and should be connected to the LEFT TUNER input.
The other lead should be connected to the RIGHT TUNER input.
5. VIDEO INPUT JACKS
Use these input jacks when connecting a video cassette recorder or a TV tuner.
6. DAT/AUX INPUT JACKS
Use these input jacks when connecting a digital audio tape player or any high level input such as TV Tuner,
2nd cassette deck, etc.
7. TAPE PLAY JACKS
The output signal coming from your Tape Deck during playback is fed into these jacks and selected as a listen-
ing source by depressing the TAPE MONITOR switch on the front panel (MONITOR ON) regardless of the
position of FUNCTION selector.
These PLAY jacks may be connected to the line output of the audio processor like an additional graphic
equalizer.
8. TAPE REC JACKS
Publicidad
