Interface Installation - OHAUS RANGER COUNT 3000 Manual De Instrucciones

2 Scale Interface
nd
INTRODUCTION
This Second Scale interface Kit is for use with the Ohaus product Ranger Count 3000. Through this
kit you can connect additional platform with Ranger Count 3000.
KIT CONTENTS
 2
Scale PC Board
nd
 Screws (4)

INTERFACE INSTALLATION

Install the Interface module on the underside of the balance as shown.
1. Remove the red interface options cover. Break off the plastic blocker from the option cover.
2. Install the Interface PCB. Push it through the pins and secure it with the 4 screws.
Pins
3. Connect a cable.
4. Place the cord in the groove and put the red interface option cover back on.
 Pressure Button
 Instruction Manual
Groove
for cable
EN-1
Screws