Interface Installation - OHAUS RANGER 3000 Manual De Instrucciones

RS232 Interface
INTRODUCTION
This RS232 interface Kit is for use with the following Ohaus products: Ranger 3000,
Ranger Count 3000 and Valor 7000.
KIT CONTENTS
 RS232 PC Board
 Screws (4)

INTERFACE INSTALLATION

Install the Interface module on the underside of the balance as shown.
Note: The appearance of your model may be different.
1. Remove the red interface options cover.
2. Install the Interface PCB. Push it through the pins and secure it with the 4 screws.
 Pressure Button
 Instruction Manual
Pins
Groove
for cable
EN-1
Screws