To avoid breakage:
Do NOT handle or manipulate
the unit by the cooktop.
The counter=top
around
the cut=out should
be flat and leveled
(see
hatched area on illustration
1).
Before installing
the unit, measure
the heights
of the two (2) cabinel
sides (H1=4), front and back (see illustration
1) from the floor to the top
of the counter.
1 ½" Max.
Level the range using the
four (4) leveling legs, so that
the height from the floor to
the underside
of the metal
flange is greater than the
tallest cabinet measurement
by at least 1/16" (0,16 cm)
(see illustration
2).
(3.8 cm
Shave
Raised
Edge
to Clear
Space for a
31½" (80 cm)
Wide Cooktop.
Slide the unit into the cabinet.
Make sure the center of the unit is
aligned with the center of the cabinet cut=out.
Illustration
1
Remove
the protective
channels
on each side of the cooktop
(if
provided).
The metal flange under each side of the cooktop MUST be placed
/
over the cabinet countertop
for proper unit support. The cooktop
should NOT rest directly on the countertop
(see illustration
2) or
else it could cause damage
to the cooktop voiding the warranty.
Level the unit if needed.
After the installation,
MAKE SURE that
the unit is supported
by the two front
leveling legs and
the two adjustable
leveling wheels
and NOT by the
cooktop.
2
2"
To successfully
install the
range, the
initial level
height from
floor to
underside of
cooktop flame
should be at
least 1/16"
(0,16 cm) taller
than cabinet
sides as
measured in
step 2.
5