Broan Elite EPD61 Serie Instrucciones De Instalación página 4

1. INSTALLDUCTWORK AND ELECTRICAL WIRING
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to
perform most efficiently.
Install proper-sized ductwork, elbows and roof or wall
cap. Connect metal ductwork to cap and work back
towards the hood location. Use 2" metal foil duct tape
to seal the joints.
Run 3-wire power supply cable to installation location.
For best capture of cooking impurities, the bottom
of the hood must be located at a minimum
distance of 36" above cooking surface.
,_--_-'"_..,._ R_OF CAP
10" ROUND D UCT
0_ WALL CAP
OPTIONAL DECORATIVE r_- _,,,_ /
rt#
J.._..j_l I 10" ROUND
l _ 1 ::,{TO t 'aDAPTER
1.8"/ TOP OF WOOD
t
36"
MINIMUM ABOVE
COOKING SURFACE
HH0182A
2. PREPAREINSTALLATION
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or
damaged, contact the manufacturer.
Make sure that the following items are included:
- Range hood
- Wood strip (attached to back of hood)
- Installation manual
- Accessories including:
Baffle filters with handles: 3 for 36" width model and 4 for 48" width model
10" round adapter (taped inside the hood)
Bag of parts: 3 waterproof wire connectors, 2 no. 8 x 5/8" screws, 6 no. 10 x 2" hex head screws,
4 no. 10 x 2" flat head screws, 2 wall anchors, 2 washers 3/16" ID x 3/4" OD
Included in parts bag, but not to be used (please discard): 2 wire clamps LP16-AR
2 no. 8 x 3/8" zinc-plated screws, 8 no. 8 x 3/8" stainless steel screws,
4 stainless steel 10-32 Iocknuts, 4 washers 3/16" ID x 3/4" OD
-4-