FOR USERS IN THE UK, EIRE, MALTA AND CYPRUS ONLY.
If your sewing machine is fitted with a 3 pin non-rewireable BS plug then please read the following.
IMPORTANT
If the available socket outlet is not suitable for the plug
supplied with this equipment, it should be cut off and
an appropriate three pin plug fitted. With alternative
plugs an approved fuse must be fitted in the plug.
NOTE: The plug severed from the main leads must
be destroyed as a plug with bared flexible cords is
hazardous if engaged in a live socket outlet. In the
event of replacing the plug fuse, use a fuse approved
by ASTA to BS 1362, i.e. carrying the
rating as marked on plug.
Always replace the fuse cover. Never use plugs with
the fuse cover removed.
WARNING: DO NOT CONNECT EITHER WIRE TO
THE EARTH TERMINAL WHICH IS MARKED WITH
THE LETTER 'E', BY THE EARTH SYMBOL
COLOURED GREEN OR YELLOW.
Connecting Plugs and Main Power / Sewing Light Switch
1. Connect the three-prong plug into the machine.
2. Connect the electrical supply plug into a wall
outlet.
-
When leaving the sewing machine unattended,
the main switch of the machine must be switched
off or the plug must be removed from the socket
outlet.
The wires in these main leads are coloured in ac-
cordance with the following code:
As the colours of the wiring in the main lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, pro-
ceed as follows:
mark,
The wire which is coloured blue must be connected
ASA
to the terminal which is marked with the letter 'N' or
coloured black or blue.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter 'L' or
coloured red or brown.
OR
Turn on or off the switch for the main power and sew-
light.
1 Turn on
2 Turn off
-
When servicing the sewing machine, or when
removing covers or changing lamps, the ma-
chine or the electrical set must be disconnected
from the supply by removing the plug from the
socket outlet.
Blue
Neutral
Brown
Live
1
2