Publicidad
3) Standby (Hors Gel) Mode
It is the mode enabling to maintain a temperature of approximately 7°C in the room in case of prolonged
absence from the house.
a) Leave switch
on the Marche position.
b) Set the knob
to
.
4) Turbo mode
It is the mode enabling to set the device into Forced Operation, ensuring prompt temperature increa-
se in the room over the time defined (maximum power for conventional models and fan activation point
for models with ventilating fan).
a) Leave the switch
on the Marche position.
b) Select the time for the Turbo using the knob
c) Press the command
, the indicator
lights.
d) The TURBO mode can be interrupted manually before the end of the time set. In order to do this,
press the command
again.
NB: On a piloted or independently programmed appliance, only the Stop and Anti-frost instructions have
priority when the TURBO mode is activated (the other instructions are ineffective).
5) Locking commands
It is possible to lock the knob
or restrict its use, preventing untimely handling of the device –(chil-
dren...).
1- Locking the knob:
a) Set the knob to the position required.
b) Using a small-size flat-blade screwdriver, pull the knob's cap (1).
c) Detach pin P from its stand using a cutting tool.
d) Set pin P in the alignment of arrow B (2).
e) Refit the cap.
2- Limitation of the knob's use range:
a) Using a small-size flat-blade screwdriver, pull the knob's cap (1).
b) Remove the two P pins from their stand using a cutting tool.
c) Position the two P pins at each end of the operating range desired (3).
d) Refit the cap.
1
2
R
ECOMMENDATIONS OF USE
- When ventilating the room, stop the device by setting the switch
- If you leave for several hours, lower the temperature.
Leaving for:
Less than 24 hours
More than 24 hours or during summer :set the temperature knob to
.
3
P
P
B
to the Arrêt position.
:do not touch the controls.
F i l t r o
a n t i p o l v o
(para modelo equipado de un ventilador)
El ventilador está equipado de un filtro antipolvo
que, cuando se satura, puede provocar su parada
(piloto rojo encendido debajo del aparato).
Para una mejor utilización, limpie su filtro regular-
mente siguiendo las instrucciones:
1. Apague el aparato.
Interruptor Marcha/Parada
3. Limpie el filtro.
5. Espere 10 minutos antes de la puesta en marcha del aparato.
Estas instrucciones figuran sobre el ventilador bajo la forma siguiente :
.
2.Tire del filtro situado en la parte trasera del aparato.
4.Vuelva a colocar el filtro.
Parte por limpiar
Indicator rojo
Publicidad
