Bosch 0.615.990.CY3 Instrucciones De Servicio página 19

OBJ_BUCH-315-002.book Page 18 Monday, June 11, 2007 12:59 PM
Rough Sanding
Attach a sanding sheet with coarse grain.
Apply only light pressure to the machine so that it runs
at high speed and high material removal is achieved.
Fine Sanding
Attach a sanding sheet with fine grain.
By lightly varying the application pressure or changing
the speed stage (GEX 125-1 AE), the sanding plate
speed can be reduced whereby the orbital action is
maintained.
With moderate pressure, move the machine in a circu-
lar pattern or alternately in lengthwise and crosswise
directions over the workpiece. Do not tilt the machine
to avoid sanding through the workpiece (e. g. when
sanding veneer).
After finishing the working procedure, switch the
power tool off.
Polishing (GEX 125-1 AE)
For the polishing of weathered paint or buffing out
scratches (e. g., acrylic glass), the machine can be
equipped with appropriate polishing accessories
such as lamb's wool bonnet, polishing felt or sponge
(accessories).
Select a low speed for polishing (stage 1 – 2) in order
to avoid excessive heating of the surface.
Apply polishing agent crosswise or in a circular
motion with a polishing sponge and moderate pres-
sure, and then allow it to dry lightly.
Polish the partially dried polishing agent with cross-
wise or circular motions using a lamb's wool polishing
bonnet.
Clean the polishing accessories regularly to ensure
good polishing results. Wash out polishing accesso-
ries with a mild detergent and warm water; do not use
paint thinner.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Bosch power tools.
In all correspondence and spare parts order, please
always include the 10-digit article number given on
the type plate of the machine.
18 | English
WARNING! Important instructions for connect-
ing a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to the
following code:
Do not connect the blue or brown wire to the earth
terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it must be
disposed of safely.
After-sales service and customer
assistance
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Exploded views and information
on spare parts can also be found under:
www.bosch-pt.com
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: SPT-Technical.de@de.bosch.com
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: +353 (01) 4 66 67 00
Fax: +353 (01) 4 66 68 88
2 609 140 411 • 11.6.07