Hoshizaki FM-170AFE Manual De Instalación página 5

ENGLISH
Fig. 7
6. START-UP PROCEDURE
1) Check that the power supply cord is disconnected.
2) Move the Operation Switch on the Operation Panel
to the "ON" position.
3) Open the water supply tap.
4) Connect the power supply and energise.
5) The following should occur in sequence:
a) Water Reservoir will fill.
b) Gear Motor will start.
c) Compressor will start.
Operation Panel
Operation Switch
Circuit Breaker (6A) Motor Protector (3A)
Fig. 8
IMPORTANT
1. Check the conditions and quality of the ice
production.
2. Do not use ice produced in the trial run. It
3. Clean the Storage Bin before use (see "III. 1.
Water Supply Tap
7. FINAL CHECKS
Inlet Hose
1) Is installation free of water leaks?
2) Is the icemaker free from vibration?
3) Are all the panels fixed and secure?
4) Has the user been instructed on correct machine
use and handed the Instruction Manual?
4
might be contaminated with foreign matter in
the water circuit. Discard or flush down the
drain.
CLEANING" in Instruction Manual).