Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not load the machine unnecessarily: excessive
pressure when sawing will quickly damage the saw
blade, which results in reduced output of the ma-
chine in the processing and in cut precision
• Use the tool that is recommended in this manual.
In doing so, your machine provides optimal perfor-
mance.
• Hands may never enter the processing zone when
the machine is in operation.
• Release the handle button and switch off the ma-
chine prior to any operations.
• Danger of injury! of fingers and hands by con-
tact with the blade shaft at uncovered areas when
changing tools. These can also be crushed by open-
ing the guard.
• Eye injuries
- on the infeed and discharge opening by danger-
ous recoil
- Danger from current if the electric cables have not
been connected correctly.
- harmful wood duct may be generated if operated
without an extractor or chip bag.
- by catapulted parts
• Metal parts in the workpiece can blunt or destroy the
blades.
• Lung damage if no suitable protective dust mask is
used.
6. Technical data
Number of knives
Cutter block
Dimensions
Weight
Technical data – Surfacing
Max planing width
Max chip removal
Ripping fence l x h
Ripping fence tilting angle
Surfacing table size
Technical data – Thicknessing
Max planing width
Max planing thickness
Max chip removal
Thicknessing table size
Drive
Motor
30 | GB
Subject to technical changes!
Noise
Total noise values determined in accordance with EN
61029.
Wear hearing protection.
The effects of noise can cause a loss of hearing
The above-mentioned noise emission values were
measured in accordance with a standardised test pro-
cedure and can be used to compare one power tool
with another.
The above-mentioned noise emission values can also
be used for the preliminary assessment of exposure.
Warning:
• The noise emissions during the actual use of the
2 pieces
• Try to keep emissions as low as possible, for ex-
9000 RPM
770 x 450 483 mm
24 kg
204 mm
7.
2,5 mm
540 x 105 mm
• Open the packaging and remove the device care-
90°–135°
• Remove the packaging material as well as the pack-
740 x 213 mm
• Check that the delivery is complete.
204 mm
• Check the device and accessory parts for transport
120 mm
2 mm
• If possible, store the packaging until the warranty
250 x 270 mm
• Familiarize yourself with the machine with the help
230-240V~ / 50 Hz
www.scheppach.com
Consumption power P1
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
power tool may differ from the above-mentioned
values depending on the power tool being used, in
particular on the type of workpiece being processed.
ample by limiting your working time. In this regard,
all the operational cycle phases must be taken into
consideration (such as the times when the tool is
switched off or running idle).
Unpacking
fully.
aging and transport bracing (if available).
damage. Inform the transport agent immediately of
any faults. Later complaints cannot be considered.
period has expired.
of the operating instructions manual before using it.
1500 W
92 dB
3 dB
105 dB
3 dB
Publicidad
