Ultra Wash Soil Removal System; Start-Up Guide; Using Your New Dishwasher; Important - Sears Kenmore ULTRA WASH 665.1776 Serie Manual De Uso Y Cuidado

®
ULTRA WASH
The ULTRA WASH soil removal system gives you sparkling clean
dishes, while using less energy and time. The ULTRA WASH soil
removal system includes:
A multilevel wash sytem with a self-cleaning filter.

START-UP GUIDE

Before using your dishwasher, remove all packaging materials.
Read this entire Use and Care Guide. You will find important
safety information and useful operating tips.

Using Your New Dishwasher

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A power supply of 120 volts, 60 Hz AC, 15 or 20 amps, is
required.
1. Plug into a grounded 3 prong outlet.
2. Rinse aid is essential for good drying. Be sure to fill the
dispenser before you use your new dishwasher. Each filling
will last about 1 to 3 months depending on your usage.
3. Scrape large food soil and hard items (toothpicks or bones)
from dishes.
Soil Removal System
4. Properly load the dishwasher. (See "Dishwasher Loading.")
Load dishes with space in between so water will reach the
soiled surfaces. Make sure nothing keeps the spray arm(s)
from spinning freely.
5. Add detergent. Always use a quality brand detergent. (See
"Dishwasher Use.")
6. Push the door firmly closed. The door latches automatically.
Run hot water at the sink where you will connect dishwasher
until water is hot. (See "Dishwasher Efficiency Tips.") Turn off
the water and hook the dishwasher to the faucet. (See
"Connecting the Dishwasher.") Turn on the hot water.
7. Press the desired cycle and options. (See "Dishwasher Use.")
8. Press START/RESUME, or press START/RESUME to repeat
the same cycle and options as the previous cycle.
IMPORTANT: The Start/Resume light will begin flashing if the
door is opened during a cycle. Power interruptions during a
cycle may also cause the Start/Resume light to flash. Press
START/RESUME to continue a cycle.
7