Koenic KDW 60111 A2 FS Manual De Instrucciones página 21

Installation
Note:
The dishwasher is equipped with power
cord and plug. Before installation, make sure
that a suitable wall outlet is available at the
desired place of installation.
Consider the dimension of the product for
placing and installation.
Place the dishwasher on an even,
Fig.
1
horizontal and steady surface.
Note:
The dishwasher is not intended to be built in.
Fig. The dishwasher must be connected to
2
a drainpipe.
• The hose is already connected to
the waste water outlet. Cut the
straps and unwind the hose.
• Connect the end to a drainpipe
(Option A oder B). Be aware of the
max. height of the outlet of drainage
hose.
Note:
A suitable hose holder is available as optional
accessories.
Connect the water inlet to a tap water
Fig.
3
supply (3/4") using the pre-assembled
hose and make sure it
tightly.
Note:
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is
clear and free of impurities. If this precaution
is not taken, there is a risk that the water
inlet might get blocked and damage the
appliance.
Fig. Connect the power plug to the mains.
4
IM_KDW 60111 A2 FS_170802_V08_HR.indb 21
Preparation
Putting salt into the salt container
Fig.
Note:
is fastened
Depending on how fully the salt dissolves,
the salt warning light may still be on even
though the salt container is filled.
Depending on your tap water hardness
5
(hardness degree) use additional salt
(water softener). Always consider
instruction provided with the salt.
• Remove the basket and then
unscrew and remove the cap from
the salt container.
• Before first usage, add 1.5 lt. of
water in the salt container of your
machine.
• Place the end of the funnel
(supplied) into the hole and pour in
about 1.5 kg of salt. It is normal for a
small amount of water to come out
of the salt container.
• After filling the container, screw
the cap tightly back on in clockwise
direction.
• Immediately after filling the salt
into the salt container, a washing
program should be started (rapid
program suggested). Otherwise
filter system, pump or other
important parts of the machine may
be damaged by salty water which
would void the warranty.
English
21
2/8/17 12:02 pm