Koenic KDW 60111 A2 FS Manual De Instrucciones página 26

English
6. Push Start/Pause button. To stop the
process push the Start/Pause button
again.
To start the rinsing process at a later
time, press the timer
the hours by which the start is to be
delayed by pressing it several times. A
1-24 hours start time delay can be set.
Then press the Start/Pause button.
The dishwasher starts rinsing when
the preset time has elapsed.
Note:
The program lights show the state
of the dishwasher:
• Program light on: standby or
pause.
• Program light blinking: washing
process ongoing.
7. When the working cycle has finished,
an 8 second long beep is sounded.
- Turn off the appliance using the
Ein/Aus button and shut off the
water supply.
- Open the door of the dishwasher.
It is dangerous to open the door
when washing, because the hot
water may scald you.
- Wait a few minutes before
unloading the dishwasher to avoid
handling the dishes and utensils
while they are still hot. They will
also dry better.
- Unload the dishwasher.
26
IM_KDW 60111 A2 FS_170802_V08_HR.indb 26
button. Set
Warning
Pausing the washing cycle
You can modify the washing program when the
dishwasher has just been started. Otherwise,
the detergent may have already been released,
and the appliance may have already drained the
wash water.
• Press Start/Pause button for more than
three seconds to switch to stand by state.
• Change the program to the desired cycle
setting.
• Press Start/Pause button again to
continue washing process.
Note:
If you open the door during washing, the
machine will pause. When you close the
door and press the Start/Pause button,
the machine will continue working after 10
seconds.
• If you have forgotten some dishes you can
pause a running process and add them, but
make sure the detergent compartment has
not already opened.
1. Open the door just a little to pause the
washing process.
2. After the spray arms stop working, you
can open the door completely.
3. Add forgotten dishes.
4. Close the door and press the Start/
Pause button again and the dishwasher
will continue after 10 seconds.
Child lock
• The child lock can be activated when the
dishwasher is running or started with the
start time delay.
• Press the half full button
button simultaneously for 3 seconds.
Now the dishwasher can only be switched
off. To deactivate child lock, press the two
buttons again for 3 seconds.
and the timer
2/8/17 12:02 pm