Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING BITS
Always follow the procedure below to install a driver bit.
1. Pull the guide sleeve forward. (see Fig. 3-A)
2. Insert the bit into the hexagonal hole.
3. By releasing the guide sleeve it will return to its original position.
REMOVING BITS
Always follow the procedure below to remove a driver bit.
1. Pull the guide sleeve forward. (see Fig. 3-A)
2. Take the bit out from the hexagonal hole.
3. By releasing the guide sleeve it will return to its original position.
1English1
B
Fig. 2
English
A
A = 17 mm
B = 14 mm
-8
Publicidad
