Publicidad
Idiomas disponibles
Idiomas disponibles
en
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to an App from which additional
tool functionality can be accessed . For more information on the App functionality and whether it is available in your
country, go to www .mirka .com .
Activate Bluetooth on your Mirka® DEOS as follows:
1 . Connect the power cord to mains outlet .
2 . Press and hold the rpm+ button while switching the tool on with the On/Off button .
3 . Left LED lights up (green), to indicate that Bluetooth is active .
4 . Bluetooth is deactivated when the tool is disconnected form mains outlet .
NOTE! If the App is not installed or if it is not available in your country, Bluetooth should not be activated . Bluetooth is
not applicable in the UK .
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc . and any use of such
marks by Mirka Ltd is under license . Other trademarks and trade names are those of their respective owners .
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart B
and C, RSS-GEN, RSS-247 and FCC §15 .247 .
Maintenance
Always disconnect air supply before maintenance!
Use only original Mirka spare parts!
Replacing the backing pad
The backing pad is fixed with 8 screws .
A = 8 mm (only on 70 x 198 mm)
B = 16 mm
Remove
1 . Turn the tool upside down .
2 . Remove the 4 screws (A) .
3 . Remove the 4 screws (B) .
4 . Remove the backing pad .
Install
1 . Fit the new pad .
2 . Fit the 4 screws (B) .
3 . Fit the 4 screws (A) .
4 . Finally tighten all 8 screws .
14
Mirka® DEOS 353X, 383X & Delta 663X • 110 V
A
B
A
B
B
A
B
A
Publicidad
