Getac B360 Guia De Funcionamiento página 8

•
Allow adequate ventilation around the adapter
when using it to operate the device or
charge the battery. Do not cover the AC
adapter with paper or other objects that will
reduce cooling. Do not use the AC adapter
while it is inside a carrying case.
•
Connect the adapter to a proper power
source. The voltage requirements are found
on the product case and/or packaging.
•
Do not use the adapter if the cord becomes
damaged.
•
Do not attempt to service the unit. There
are no serviceable parts inside. Replace the
unit if it is damaged or exposed to excess
moisture.
Heat Related Concerns
Your device may become very warm during
normal use. It complies with the user-accessible
surface temperature limits defined by the Inter-
national Standards for Safety. Still, sustained
contact with warm surfaces for long periods of
time may cause discomfort or injury. To reduce
potential heat-related concerns, follow these
guidelines:
•
Keep your device and its AC adapter in a
well-ventilated area when in use or
charging. Allow for adequate air circulation
under and around the device.
•
Use common sense to avoid situations where
your skin is in contact with your device or its
AC adapter when it's operating or connected
to a power source. For example, don't sleep
with your device or its AC adapter, or place
it under a blanket or pillow, and avoid con-
tact between your body and your device
when the AC adapter is connected to a
power source. Take special care if you have
a phys-ical condition that affects your ability
to detect heat against the body.
•
If your device is used for long periods, its
surface can become very warm. While the
temperature may not feel hot to the touch,
if you maintain physical contact with the
device for a long time, for example if you
rest the device on your lap, your skin might
suffer a low-heat injury.
•
If your device is on your lap and gets uncom-
fortably warm, remove it from your lap and
place it on a stable work surface.
•
Never place your device or AC adapter on
furniture or any other surface that might be
marred by exposure to heat since the base
of your device and the surface of the AC
adapter may increase in temperature during
normal use.
6
Regulatory Information
USA
Federal Communications Commission
Radio Frequency Interference Statement
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital
device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instruct-tions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equip-ment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equip-
ment and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the re-
ceiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
Any changes or modifications not expressly
approved by the manufacturer could void the
user's authority to operate the equipment.
Please note:
The use of a non-shielded interface cable with
this equipment is prohibited.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
FCC RF Exposure Information
This device has been tested and meets appli-
cable limits for Radio Frequency (RF) exposure.