Publicidad
Connect Power
Control box is located behind header. Insert power cord into control box
as shown in illustration below:
Install Final Display Mounting Screws
• Using the wired remote, push the rotate button to flatten out the display into table position
• Use (2) "H" screws to affix the mounting brackets completely to the cart-side mechanism
as shown. Tighten all screws firmly.
Salamander Designs - Electric Lift & Tilt, Mobile Display Stands
Lower Rear
www.salamandercommercial.com
Lower Rear
of Display
501-631-MS [04.20]
page 9 of 23
Publicidad
