DeVilbiss Healthcare PulmoStar 4650U Guía De Instrucciones página 4

IMPORTANT PARTS
Compressor (Figure A)
1. Storage compartment
2. Storage compartment door with operating instructions
3. Power switch
4. Filter cap
5. Air-outlet connector
6. Carrying handle
7. Power cord storage
8. Nebulizer holder
Reusable Nebulizer (Figure B)
1. Mouthpiece
2. Cap
3. Baffle
4. Medication Cup
5. Nebulizer Air-Inlet Connector
6. Interrupter Adapter (not shown)
Nebulizer parts are not sold separately. Additional nebulizers (Part # 800G) are available
through your DeVilbiss provider.
HOW TO OPERATE YOUR COMPRESSOR
NOTE– Before initial operation, your nebulizer should be cleaned following cleaning instructions, or as recommended by
your physician or DeVilbiss provider.
1. Place compressor on a level, sturdy surface so that the controls can be easily reached
when seated.
2. Open door to storage compartment (Figure 1).
3. Make sure the power switch is in the "Off" (O) position (Figure 2). Unwrap power cord
and plug power cord into an appropriate wall outlet (refer to Specifications).
dANGER
DeVilbiss compressor/nebulizer must be operated on the specified power source to
avoid risk of electric shock and damage to the compressor.
4. Wash hands.
5. Connect one end of the nebulizer tubing to the compressor air-outlet connector
(Figure 3).
NOTE– During high-humidity weather conditions, condensation (water build up) can occur in
the internal hose of the compressor. It is recommended that the compressor be turned on and
allowed to run for two (2) minutes before the tubing is attached to the air-outlet connector.
6. A ssemble clean nebulizer parts by placing baffle down in medication cup. Holding cup
stationary, screw on nebulizer cap. Add prescribed medication through the opening on
cap using a medicine dropper or pre-measured dose container (Figure 4).
7. Assemble mouthpiece and t-piece (if applicable) and insert into the top of the
nebulizer cap (Figure 5). If using an aerosol mask, insert the bottom part of the mask
directly into the top of the nebulizer cap.
8. Attach tubing to nebulizer air-inlet connector (Figure 6).
9. Press the power switch "On" (I) to start the compressor.
10. Begin treatment by placing the mouthpiece between teeth. With mouth closed, inhale
deeply and slowly through mouth as aerosol begins to flow, hold for 2-3 seconds, then
exhale slowly through the mouthpiece (Figure 7). If treatment needs to be interrupted,
simply press power switch "Off" (O).
NOTE– Nebulizer received may look different than pictured nebulizer.
NOTE– Some physicians recommend a specific breathing pattern during treatment. if so,
follow his/her recommendations.
11. If an aerosol mask is used, place the mask over mouth and nose (Figure 8). As
aerosol begins to flow, inhale deeply and slowly through mouth, then exhale slowly.
12. When treatment is complete, turn unit OFF by pressing the power switch to the "OFF"
(O) position. Unplug the unit from the wall power outlet.
EN - 4
2
8
3
1
5
6
Figure A
1
2
3
4
5
Figure B
Figure 1
Figure 2
Figure 3
SE-650
7
4