Descargar Imprimir esta página

Mesko MS 7741 Manual De Uso página 7

Ocultar thumbs Ver también para MS 7741:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
13. Do not leave the device or the power supply plug unattended when switched on.
14. To provide additional protection, it is advisable to install a residual current device
(RCD) in the electrical circuit with a rated residual current not exceeding 30 mA . In this
regard, please contact a specialist electrician.
15. Do not use the device near water, e.g. in a shower, in a bathtub or over a
sink with water.
16.When the appliance is used in the bathroom, unplug it from the socket after use, as
the proximity of water poses a risk even when the appliance is turned off.
17. Do not allow the device or power supply to get wet. If the device falls into water,
immediately remove the plug or power supply from the power socket. Do not put your
hands into the water when the device is plugged in. It must be checked by a qualified
electrician before being used again.
18. Do not handle the device or power supply with wet hands.
19. The radiator should only be placed on a flat, stable surface
20. Before removing the plug from the socket, always turn off the heater and turn the
thermostat knob to the minimum position.
21. Do not use the heater in rooms with high air humidity - bathrooms, showers,
swimming pools, etc. Humidity may cause a short circuit and damage the device.
22. The operating heater must be supervised and within sight at all times. When leaving
the room where the heater is operating, always turn it off. If the heater is not working,
always remove the plug from the socket.
23. Do not connect the heater to an automatic shut-off device, such as a thermal control
device or timer.
24. Flammable materials, e.g. furniture, bedding, paper, clothes, curtains, etc., should
be kept at a distance of at least one meter from the heater.
25. Do not cover the device during operation or place any objects on it. Do not use the
device to dry clothes.
26. The power cord cannot be laid above the radiator and should not touch or lie near
its hot surfaces. Do not place the fan heater under an electrical socket.
27. Heating surfaces may heat up to temperatures higher than 60 °C. The fan heater
should be placed in a place where children and animals do not have access to it.
28. The device cannot be installed or used in vehicles.
29. There are parts inside the appliance that may be hot or cause sparks. Do not turn
on the Heater in places where materials such as gasoline, paint or other flammable
substances are used or stored.
ASEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit. These are to be attached to the base
of the heater using the 4 self-tapping screws provided, taking care to ensure that they are located correctly in the bottom ends of the
heater side mouldings. Look at picture D.
BEFORE FIRST USE
Do not use the heater unless the feet are correctly assembled.
Do not place the device on carpets having a very high pile. Ensure that the device is not located close to curtains or furniture as this
could create a fire hazard.
7

Publicidad

loading