Installing The Handle; Optional Accessory - Makita DLM382 Manual De Instrucciones

2. Place your hands in the middle of the battery
cover and push it.
3. Before the first operation, check that the pivot
point of the battery cover is attached properly. If the
battery cover is installed correctly, it will not open until
the battery cover locking lever is pulled.
1
► 1. Pivot point 2. Battery cover locking lever

Installing the handle

NOTICE:
When installing handles, position the
cords so that they are not caught by anything
between the handles. If the cord is damaged, the
mower switch may not work.
1.
Slide the both ends of lower handle into the
grooves of the mower then fully tighten the clamping
screws.
1
► 1. Clamping screw 2. Lower handle
2. Align the screw holes of upper handle and lower
handle. Secure them with the clamping screws and
nuts.
2
► 1. Clamping nut 2. Clamping screw
NOTE: Hold the upper handle firmly so that it does
not drop off your hand.
3. Attach the holders to the handle. Position the
power supply cord as shown in the figure.
2
► 1. Holder
Removing the mulching plug

Optional accessory

1. Open the rear cover.
2
► 1. Rear cover
6 ENGLISH
1
1
2
1