Rubi DC-250 PYTHON Manual Del Usuario página 5

available or should be used with this tool. If the tool must be reconnected
should comply with all local codes and ordinances.
4. PERMANENTLY CONNECTED TOOLS:
GROUNDING METHODS:
GROUNDING
PIN
ADAPTER
GROUNDING
PIN
COVER OF
GROUNDED
OUTLET BOX
METAL SCREW
COVER OF
GROUNDED
OUTLET BOX
GROUNDING
MEANS
TABLE A / MINIMUM GAUGE FOR CORDS:
NOTE: AWG = American Wire Gauge
1. WARNING!
it was designed.
Ensure that the water level reaches the indicated level before starting
and during any cutting operation.
3. Replace the tank water periodically. Working with clean water lengthens
the life of the blade and improves its performance.
4. Remove the adjustment blade wrench and tools before starting the machine.
or deformations and broken parts and cords. If any of these are found,
do not use the tool and contact the manufacturer immediately.
6. Keep hands away from the cutting area and blade at all times.
7. Always use blades with interior diameters that correspond to the
rotate eccentrically, leading to a loss of control.
8.
functioning and safety during operation.
9.
Use only the recommended blades, suitable for RPMs that are greater
than or equal to the maximum RPM of the machine and with holes for
11. Assembly the blade plates correctly and tighten the nut properly before
starting the machine.
Verify that the blade has no cracks or other damage before operation.
13. Never start the machine with the piece to being cut in contact with the blade.
14. Never stand on the tool. serious injury could occur if the tool is tipped or
if the cutting tool is unintentionally contacted.
Allow the motor to reach its maximum speed before cutting.
16. ATTENTION!
wait for the blade to stop completely before leaving the tool.
17.
anaccidental start-up when reconnecting it to the power source.
18. Only use the machine for cutting ceramic, porcelain, glass, and natural stone.
19.
or any other malfunction. Check the machine to determine the cause.
WORK POSITION
A. Working area designed for tiles over 60 cm.
B. Working area designed for tiles up to 60 cm.
EN
- 5 -