Rubi DC-250 PYTHON Manual Del Usuario página 6

EN
position tile saw to one side of a wall mounted receptacle to prevent water
loop" in the cord connecting the saw to a receptacle.
connector if an extension cord is used, to prevent water traveling along the
cord and coming in contact with the receptacle.
examine for presence of water in the receptacle.
store indoors while not in use." Use only extension cords having an electrical
abuse extension cords and do not yank on any cord to disconnect. Keep cord
away from heat and sharp edges. Always disconnect the extension cord from
the receptacle before disconnecting the product from the extension cord.
WARNING
3. Ground Fault Circuit Interrupter (GFCI) protection should be provided on the
circuit(s) or outlet (s) to be used for the tile saw. Receptacles are available
having built-in GFCI protection and may be used for this measure of safety.
Although the wheels allow one person to transport the machine, it is
recommended that this be done by two people.
properly positioned for the transport position and with the wheels assembled.
BEFORE STARTING THE MACHINE:
1.
3.
possible movements during transport. Loosen knob B to release the
INSTALLING AND REPLACING THE BLADE:
4.
6. Mount the blade between the plates, matching the direction of rotation
indicated on the machine.
7.
WATER FEED SYSTEM:
8.
- 6 -
9. It is important to replace the water regularly, since using the machine
with clean water prolongs the life of the blade and improves its
performance.
COOLING POINT ADJUSTMENT:
11.
of the tile to be cut. It can rotate with respect to the rotation axis of the
blade.
this does not rub against it.
ADJUSTING THE ANGLE AND DEPTH OF CUT:
13.
allows the head to be placed in the required position.
14.
the cutting position.
the blade is perpendicular to the piece being cut.
by a set of springs which, in turn, compensate for the weight of the
16.
PRELIMINARY CHECKS:
17. Before using the machine, check for any worn, damaged or broken parts
and immediately repair or replace any that are found.
18. Level the machine.
19.
Check that the mains voltage and frequency correspond to that
indicated on the machine's technical data plate.
cutting, the guard should therefore be adjusted according to the
thickness of the piece to be cut.
the machine by pulling on the power cord.
If the blade is installed incorrectly and is working in the wrong direction,
stop the machine and correct the blade installation.
Use only the blade diameters indicated in this manual.
STRAIGHT CUT
hand on the main handle and slide the cutter head along the guide.
provides better balance and sliding of the cutter.
MITER CUT
hand on the main handle and slide the cutter head along the guide. For
greater comfort, place the other hand on the machine chassis or hold
Read these instructions carefully before using this product and do not
throw them away.