Publicidad
Idiomas disponibles
Idiomas disponibles
2. Loosen the nut to adjust the spring tension.
To start the engine
1. Sit on the seat.
2. Push the PTO button to disengage the drive on
the cutting deck.
3. Set the cutting deck in transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 13 .
4. Engage the parking brake. Refer to
and disengage the parking brake on page 13 .
5. Move the throttle lever (A) to ½ throttle position.
A
B
6. Turn the fuel tank valve to select 1 of the 2 fuel
tanks.
7. Set the cutting height. Refer to
height on page 13 .
8. Press and turn the ignition key to the start
position (B).
9. When the engine starts, immediately release the
ignition key to the run position.
Note:
Do not keep the ignition key in the start
position for more than 5 seconds at a time. If the
engine does not start, wait 15 seconds before
you try again.
14
To engage
To set the cutting
10. Let the engine run at ½ throttle for 3-5 minutes
before you apply full throttle.
11. Push the throttle control to the full throttle
position.
To operate the product
1. Start the engine. Refer to
page 14 .
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 13 .
3. Carefully push the 2 control levers forward. The
product will start to move forward. The forward
speed increases the more the 2 control levers
are pushed forward.
4. Carefully pull the 2 control levers rearward. The
product will start to move rearward. The rearward
speed increases the more the 2 control levers
are pulled rearward.
5. Put the 2 control levers in neutral position to
decrease the speed and stop the product.
6. Do the steps that follow to turn left or right when
you go in a forward direction.
a) Pull the left control lever rearward in the
direction of the neutral position to make the
product turn left. The more you pull the left
control lever rearward, the more the product
will turn left.
To start the engine on
To
2320 - 001 - 29.11.2023
Publicidad
