Publicidad
Idiomas disponibles
Idiomas disponibles
•
Wear gloves when necessary, for example
when you attach, examine or clean the cutting
equipment.
•
Do not wear loose-fitting clothing, jewelry or
other items that can get caught in moving parts.
•
Do not wear shorts when you operate the
product.
•
Keep first aid equipment and fire extinguisher
close at hand.
Safety devices on the product
WARNING:
instructions that follow before you use
the product.
•
Do not use a product with safety devices that
are damaged or do not operate correctly. Do a
check of the safety devices regularly. If the safety
devices are damaged, speak to your Husqvarna
service agent.
•
Do not make modifications on safety devices. Do
not use the product if protective plates, protective
covers, safety switches or other protective
devices are not attached or are damaged.
Malfunction indicator light
The malfunction indicator light (MIL) shows the
operator if there is a problem with the engine. Refer
to the operator's manual for the engine.
To engage and disengage the Roll Over Protection
Structure (ROPS)
•
Remove the 2 pins that hold the ROPS and fold
it rearwards to disengage. Engage the ROPS in
the opposite sequence.
2320 - 001 - 29.11.2023
Read the warning
WARNING:
instructions for the ROPS and the
safety belt.
•
Do not use the safety belt if the ROPS is
disengaged.
•
Always use the safety belt when the ROPS is
engaged.
•
Make sure that the ROPS is correctly attached
and not damaged.
To do a check of the ignition key
•
Start and stop the engine to do a check of the
ignition key. Refer to
14 and To stop the engine on page 15 .
•
Make sure that the engine starts when you turn
the ignition key to start position.
•
Make sure that the engine stops immediately
when you turn the ignition key to stop position.
Operation conditions
These conditions are necessary to start the engine:
•
The control levers are in the neutral position.
•
The parking brake is applied.
•
The drive of the blades is disengaged.
The engine must stop in these situations:
•
The parking brake is not applied and the operator
lifts from the seat.
•
The drive of the blades is engaged and the
operator lifts from the seat.
Try to start the engine without 1 of the conditions.
Change the conditions and try again. Do this check
daily.
Parking brake
WARNING:
does not work, the product can start to
move and cause injury or damage. Make
sure that the parking brake is regularly
examined and adjusted.
To examine and adjust the parking brake on
Refer to
page 18 .
Muffler
WARNING:
if the muffler is missing or damaged.
A muffler that is damaged or missing
increases the noise level and the risk of
fire.
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
Obey the following
To start the engine on page
If the parking brake
Do not use the product
9
Publicidad
