GE 25 Serie Manual Del Propietario Y Instalación página 16

Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker
The i(emaker xdll have to be (onne(ted to a (old
water line.
You can order a GE water supply kit (containing
robing, shutoflv:dve, fittings and instructions) by
visiting our Website at nnN_GEAppliances.com or
flom Parts and Accessories, 800-626-2002.
Refrigerator Location
Do not install the refligerator where the
temperature will go below 60°F (16°()
becmlse it will not run often era)ugh to maintain
proper temperatures.
Install it on a floor strong enough to support it
fhlly loaded.
Clearances
Allow the folloxdng clearances fi)r ease of
installation, proper air dr(ulation and
plumbing and ele(tri(al _ onne_ tions:
Sides 1/8"(4 mm)
Top 1" (25mm)
Back 1"(25 mm)
Rollers
The milers have 3 purposes:
Rollers a(!just so die door closes easilywhen
opened about halfivay. [Raise the fiont about
5/8" (15 Inln) fi'Oln the floor.]
Rollers adjust so the refiigerator is firmly
positioned on the floor and does not wobble.
Rollers alh)w you to move the refiigerat or away
fi'om the wall for (leaning.
Final leveling a(!iustments should be made after the
refiigerator has been installed.
Toadjust the milers:
Turn the roller adjusting screws clockwisetoraise
the refiigerator, counterclockwise to Iowerit. Use a
3/8" hex so{ket or x_en{ h, or an a(!justable x_aen( 11.
/6
Roller adjusting screw