Descargar Imprimir esta página

Ryobi ONE+ PCL001 Manual Del Operador página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

ACCESSORIES
See Figures 7 - 9, page 10.
The supplied accessories perform a variety of functions.
The tapered adaptor can be used on smaller pinch valves to
inflate items like small rafts, which usually require the user to
inflate them by blowing air into them. The sport ball needle
can be used to inflate any type of sports ball or any other
item that requires an inflation sport ball needle.
NOTE: When inflating items of 10 PSI or less, inflate in short
bursts and check after each burst by feel or with a calibrated
measuring device to determine accurate pressure.
SPORT BALL NEEDLE
NOTICE:
Insert the sport ball needle only until its base is flush
with the surface of the air chuck. Do not insert the sport
ball needle all the way into the chuck. Installing the sport
needle incorrectly can damage the gauge, air chuck, or
other parts of the inflator.
WARNING:
When servicing, use only identical replacement parts. Use
of any other parts can create a hazard or cause product
damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
NOTE: ILLUSTRATIONS START ON PAGE 9 AFTER FRENCH AND SPANISH
OPERATION
 Insert sport ball needle into sports ball valve and inflate.
 Remove sport ball needle after inflation.
NOTE: Pressure required for most sports balls is too low for
accurate reading on tool gauge.
PRESTA VALVE ADAPTOR
Before inflating a tire with a Presta valve, loosen the locking
nut on the valve stem to inflate. Once inflation is complete,
tighten the locking nut to seal the tire valve.
 Loosen the Presta valve locking nut.
 Thread the Presta valve adaptor onto the valve stem with
the larger open end toward the wheel.
 Position the air chuck clamp in the unlock position.
 Clamp the end of the air chuck down onto the Presta
valve adaptor by pressing air chuck clamp down until it
locks into place.
 After inflation, remove air chuck and tighten locking nut.
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
LANGUAGE SECTIONS.
8 — English
WARNING:

Publicidad

loading