Publicidad
Idiomas disponibles
Idiomas disponibles
EN
16
DEVICE OVERVIEW
1
Rear cover
2
Cup holder
3
Middle frame
4
Rear housing
5
Fan
Installation
•
When transporting the device, make sure that the tilt angle of the housing is
not more than 45°. Otherwise the compressor and the sealing system can be
damaged.
•
Remove all packing materials and ensure that the device is in good condition
and that the device, plug, or power cord are not damaged.
•
Place the device horizontally on a level surface. Keep a minimum distance
of 150 mm to each side of the device to ensure adequate ventilation. Do not
install the device near stoves, heaters or other heat sources.
•
Make sure that the voltage used corresponds to the voltage specified on the
type plate of the device.
•
Use normal drinking water for the device. The use of distilled water is
prohibited.
6
Front cover
7
Control panel
8
Housing front
9
Evaporator
10 Water bowl
11 Access board
12 Ice level sensor
13 Ice bucket
Publicidad
