Fnirsi 2C23T Manual página 41

⑥Trigger level:
trigger cursor. The interface appears
trigger voltage. At this point, short press the up and down buttons of the
direction keys to adjust the trigger.
⑦Oscilloscope channel 1 setting:
When the operating channel is
in use, short press
. When the operating
in use, short press
a window to set the switch,
magnification
coupling (AC, DC) of oscilloscope
channel 1, as shown in the figure. At
this point, press the direction keys
to set up, down, left, and right.
⑧Oscilloscope channel 2
operating the channel is
use, short press
,when operating the channel
, short pressing
pop up a window to set the switch,
magnification
coupling (AC, DC) of oscilloscope
channel 2, as shown in the figure. At
this point, press the direction keys
to set up, down, left, and right.
⑨Trigger setting:Used to set the
trigger mode, trigger channel, and
trigger type. Short press
to pop up the settings, as shown in
the figure. At this point, press the
direction key to set up, down, left,
and right.
Trigger voltage condition, short press the
to switch
will pop up
(X1, X10),
setting:When
to switch
(X1, X10),
， indicating the adjustment of the
is
and
in
will
and
34
to adjust the