Publicidad
Idiomas disponibles
Idiomas disponibles
For assistance with your product, visit our website at
PROBLEM
The power wand tool
does not turn ON
The power wand tool
turns ON (pump hums
when trigger is pulled)
but it will not spray.
The power wand tool
turns ON but only
sprays at low pressure.
The power wand tool
does not fully prime.
14
TROUBLESHOOTING GUIDE
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
POSSIBLE CAUSE
Ensure the power wand tool is charged.
The power wand tool may have
overheated.
There is no liquid in the tank.
The nozzle is clogged.
The in-tank filter is clogged.
The power wand tool is not primed.
The hose is not connected to the power
wand tool.
The power wand tool is clogged.
The nozzle is clogged.
The power wand tool is clogged.
The hose is not fully seated at the power
wand tool or the tank connection.
The in-tank filter is clogged.
The power wand tool is clogged.
The liquid level in the tank is low.
There is chemical residue or buildup in
the tank and/or pump due to improper
or inadequate cleaning.
The in-tank filter is improperly installed,
missing, or damaged, allowing debris to
enter the pump.
The hose is not fully seated at the power
wand tool or the tank connection.
www.thefountainheadgroup.com
Charge the power wand tool. See
Charging the Power Wand Tool.
Allow the power wand tool to cool.
Add liquid to the tank. See Filling the
Sprayer.
Clean the nozzle. See Nozzle Maintenance.
Clean the in-tank filter. See In-Tank Filter
Maintenance.
Allow at least 30 seconds for the pump
to prime.
Connect the hose to the power wand
tool and press the trigger to prime the
power wand tool. See Attaching the Hose
Assembly to the Power Wand Tool.
Replace power wand tool.
Clean the nozzle. See Nozzle Maintenance.
Replace power wand tool.
Disconnect and reconnect both ends of
the hose. See Attaching the Hose Assembly
to the Tank and Attaching the Hose
Assembly to the Power Wand Tool.
Clean the in-tank-filter. See In-Tank Filter
Maintenance.
Replace power wand tool.
Add liquid to the tank. See Filling the
Sprayer.
Clean the sprayer. See Cleaning. If
necessary, repeat with warm water and a
mild detergent mixture. Allow the mixture
to stay in the pump for up to 1 hour prior
to rinsing. Replace the power wand tool
if necessary.
Clean the sprayer. See Cleaning. If
necessary, repeat with warm water and a
mild detergent mixture. Allow the mixture
to stay in the pump for up to 1 hour prior
to rinsing. Replace the power wand tool
if necessary.
Disconnect and reconnect both ends of
the hose. See Attaching the Hose Assembly
to the Tank and Attaching the Hose
Assembly to the Power Wand Tool.
or call 1-800-311-9903.
SOLUTION
Publicidad
