Publicidad
Idiomas disponibles
Idiomas disponibles
Battery Life Indicator
1. Push the power switch (1) to the ON position.
A light (2) above the power switch turns on to
indicate the battery level. See Figure 9.
2. Battery indicator lights:
a. Green light: Sufficient charge
b. Yellow light: Medium charge
c. Red light: Low battery, need to charge
NOTE: When the red light activates, the sprayer will
spray for approximately one gallon, depending on
the nozzle setting.
Spraying
WARNING: RISK OF PERSONAL INJURY AND/OR
PROPERTY DAMAGE DUE TO UNINTENDED SPRAYING
OF CHEMICALS. Ensure the trigger on the power
wand tool is not engaged before powering ON the
sprayer. Once powered ON, the pump will spray if the
power wand tool trigger is depressed.
1
2
3
Figure 8
Figure 9
NOTICE: RISK OF PROPERTY DAMAGE. Only spray
when the air is calm (no wind or air movement) to
prevent chemical spray from drifting onto non-
targeted surfaces.
1. Push the power switch (1) to turn ON. The light
above the power switch turns on. See Figure 10.
2. Aim the power wand tool in the desired direction
of spraying and squeeze the trigger (2).
3. To turn off the power wand tool, push the power
switch (1) to the OFF position. The light above
the power switch turns off.
4. Always remove any chemicals, and clean the
power wand tool when finished. See the Cleaning
and Storage sections of this manual.
1
CLEANING
WARNING: Always release pressure from the power
wand tool prior to cleaning. Disassembly of a sprayer
that is still pressurized may result in the high-speed
ejection of components.
WARNING: RISK OF PERSONAL INJURY DUE TO
CHEMICAL EXPOSURE. Use the appropriate Personal
Protective Equipment (PPE) as recommended by the
chemical manufacturer and/or refer to the chemical
Safety Data Sheet (SDS) of the chemical being used.
This includes at least goggles, gloves, and protective
clothing.
WARNING: RISK OF DAMAGE TO INTERNAL
COMPONENTS. Failure to properly rinse out the
2
sprayer may allow chemical residue build-up that can
clog or damage the filters, power wand tool, wand
extension, and nozzle. Chemical residue build-up can
1
also contaminate subsequent applications. Leaving
chemical liquids in the sprayer when not in use can
lead to premature sprayer wear. Never store the
sprayer with chemicals in any part of the sprayer.
1. Ensure the power wand tool (E) is OFF and
remove the power wand tool. See Figure 11.
2. Remove the cap (1) and the filter basket (2)
and empty any extra chemical from the tank
into a suitable container for later use or dispose
according to the chemical manufacturer's
instructions.
2
Figure 10
9
Publicidad
