Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING: RISK OF PERSONAL INJURY AND/OR
PROPERTY DAMAGE DUE TO CHEMICAL EXPOSURE.
After initial assembly, always inspect the sprayer for
damage, and test it with plain water to check for
proper function. Ensure all connections are secure
and leak free, and the hose is free from damage, prior
to using the sprayer with chemicals.
WARNING: Only use attachments recommended or
sold by the manufacturer.
WARNING: For Household Use Only.
OPERATING 3-IN-1 NOZZLE
WARNING: Read Safety Precautions! Always
make sure the trigger is not activated before rotating
nozzle to different spray setting. Make sure arrow
indicators are aligned before spraying. Failure to do so
may result in leaks.
Rotating
1. Rotate 3-in-1 nozzle (B) to desired nozzle
position.
2. Nozzle end will fall into place as arrow
indicators (1) become aligned. See Figure 1.
B
3-in-1 Nozzle Settings
Stream
• Spot spraying in flower beds, walkways, driveways,
and patios, around trees and shrubs.
• Edging along fences, driveways, and walkways.
Fan
• Lawn replacement. Kill lawn and weeds before
planting a new lawn.
• Preparing large areas for planting of ornamental and
vegetable gardens.
Cone
• Killing brush such as poison ivy, poison oak, kudzu,
and wild blackberry.
• Preparing garden beds for planting of ornamentals
and vegetables.
6
Attaching the Hose Assembly to the Tank
CAUTION: Do not attempt to heat or alter hose or
barb prior to assembly.
1. Align hose barb tabs with the cap, push hose
barb into cap until it stops. See Figure 2.
2. Continue to push hose barb into cap. Turn hose
barb clockwise to secure it to the cap.
NOTE: Do not use tools to tighten hose barb or cap.
NOTE: Remove hose when not in use, empty tank
contents, and then attach the tethered cap plug. See
Tethered Cap Plug Installation.
Attaching the Hose Assembly to the Power Wand Tool
Install the hose assembly (F) onto the power wand
tool. Turn clockwise to tighten. See Figure 3.
1
F
Attaching the Wand Extension
Install the wand extension (C) onto the power wand
Figure 1
tool (E). Turn clockwise to tighten. See Figure 4.
Attaching the Nozzle
Install 3-in-1 nozzle (B) onto the end of the wand
extension (C). Turn clockwise to tighten. See Figure 5.
1
2
E
Figure 2
Figure 3
C
Figure 4
C
B
Figure 5
Publicidad
