Broan MD6TU Manual Del Usuario página 3

BROAN
MODELS MD6TU « MD8TU
TYPICAL INSTALLATIONS
Page 3
Installations will vary according to the location in the home where the unit is installed and which model Damper is used. Use the following
illustrations and notes as guidance for your own installation. Always comply with local code requirements and in any instance where a detail
shown below conflicts with local code, the local code provision shall apply.
CENTRAL SYSTEM SUPPLY AIR —
THERMOSTAT ———————__] |
I
Vy
=: « EXTERIOR WALL
HEATING APPARATUS
AIR DISTRIBUTION FAN ©
{ 9
CENTRAL SYSTEM RETURN AIR
INSULATED OUTSIDE
AIR DUCT (slope toward wall cap}
——— FRESH AIR INLET WALL CAP
WITH BIRD SCREEN
— VENTILATION AIR INTAKE
(locate away from pollutant sources)
FIELD MEASUREMENT OF OUTSIDE
AIR DUCT PRESSURE. (See "Install The
Damper" section on page 3 for damper
balancing instructions.)
AUTO. MAKE-UP AIR DAMPER
COOLING APPARATUS
AIR HANDLER UNIT
REGISTER BOX ADAPTED
WITH SLIDE-IN FILTER (optional)
FURNACE FILTER
Damper connected to return side of central duct system.
—Vy—-
INTERIOR WALL
WALL
REGISTER
EXTERIOR WALL
INSULATED OUTSIDE
AIR DUCT (slope toward wall cap)
WALL CAP WITH
BIRD SCREEN
VENTILATION AIR INTAKE
(locate away from pollutant sources)
FIELD MEASUREMENT OF OUTSIDE
AIR DUCT PRESSURE. (See "Install The
Damper" section on page 3 for damper
balancing instructions.)
MOTORIZED DAMPER
REGISTER BOX ADAPTED
WITH SLIDE-IN FILTER (optional)
Damper and outside air duct connected directly to a ceiling, floor, or wall register.