Broan MD6TU Manual Del Usuario página 5

BROS
®
MODELS MD6TU « MD8TU
Page 5
LOCATION OF PROBE AND PRESSURE SWITCH
The probe must be mounted between the range hood damper
and the wall cap, roof cap, in-line blower or external blower.
Mount the probe as close to the hood outlet as possible but
make sure the hood damper operation is not affected.
ROOF CAP
w/DAMPER
/ x |
IN-LINE i
DAMPER —~7 i} ExHausT
DUCT
o | F+-— PRESSURE
Hoon ~~ | SWITCH
FLUE a
PROBE
~~
[ts~ézd h-~— RANGE
HOOD
——IL_]
LH
TYPICAL INSTALLATION WITH
INTERNAL BLOWER AND ROOF VENT
WALL CAP
w/DAMPER
IN-LINE
LN
DAMPER ~ =
HOOD ~~ LT pressure
|_-— EXHAUST
7 DUCT
SWITCH
PROBE
RANGE
HOOD
TYPICAL INSTALLATION WITH
KITCHEN ~~ |
CABINET
PRESSURE ——~]
SWITCH
TUBING
PROBE
WALL CAP
w/DAMPER
RANGE
HOOD
TYPICAL INSTALLATION WITH
INTERNAL BLOWER AND HORIZONTAL
The pressure switch should be mounted so it is accessible for
any future service. The switch can mounted no more then 72"
away from the probe. If longer tubing is required then what is
supplied, purchase 1/4" |.D. PVC tubing from a local source. See
the illustrations below for possible installation scenarios.
ROOF CAP
w/DAMPER
INLINE
BLOWER
ct
| ~~ EXHAUST
DUCT
Hoop ~~] tre
t+ PRESSURE
FLUE SWITCH
PROBE
RANGE
HOOD
TYPICAL INSTALLATION WITH INLINE BLOWER
EXTERIOR
BLOWER
P~— EXHAUST
DUCT
b> PRESSURE
SWITCH
PROBE
HOOD ~~" tr
RANGE
HOOD
TYPICAL INSTALLATION
WITH EXTERIOR BLOWER