GE PSA1200 Instrucciones De Instalación página 16

Installation Instructions
To use toggle bolts:
Spacingfor TogglesMore
-_1_--_,_-- ThanWall Thickness
Mounting ToggleWings
Plate_. !
Wall
Bolt End
[_ Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTI O N:
Be careful to avoid pinching
fingers between the back of the mounting
plate and the wall.
[_ Tighten all bolts, Pull the plate away from the wall
to help tighten the bolts.
r_USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
u hole large enough for the power cord to fit through.
. Read the instructions on the TOP CABINET
TEMPLATE.
. Tape it underneath the top cabinet.
. Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
JuLL, t'_U/IIU |_1: Wear safety goggles when
drilling holes in the cabinet bottom.
[=_ ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
[_3 Remove the three screws that hold the blower
plate to the oven. Slide blower plate from under
its retaining flange. Remove and save the screw
that holds blower motor to oven.
Retaining _ _i!b_<_
Flange
\ ,owerP,ate
__ Blower M otor
Screw
[_3 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
End
[_3 Rotate blower unit counterclockwise 180°.
Before Rotation After Rotation
Backof
Oven Oven
3acl< of
[_ Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
BeforeRerouting After Rerouting
Wires RoutedThroughRightSide Wires Routed ThroughLeft Side
16