GE PSA1200 Instrucciones De Instalación página 17

Installation Instructions
[_ Roll the blower unit 90° so that fan blade openings
are facing out the buck of the oven.
Before Rollim
Back of
Oven
After Rolling
Backof
Oven
%
Locate the two "knockout" plates, on the rear oven
panel, near the top of the oven.
Using tin snips, carefully cut the web area from the
two holes side-by-side (that secure the knockouts to
the oven). Cut all four webs on both rear knockouts;
this will allow the ventilation fun airflow to exhaust
out the rear of the oven.
Ar-^l I-T-i_m
n_u/iul_: Be sure t otrim the sharp
edges from the openings after removing the
knockout plates.
Oven Rear Panel
Snip all 4webs
oneachknockout
panel a ndremove
____ themetalknockouts
[_ Place the blower unit back into the opening.
jEnd A
EndB ) J ,_.._ ...........
WA RNING: Risk ofelectric shock
can cause injury or death. Do not pull or stretch
the blower unit wiring, make sure the wires are
not pinched..
NOTE:The blower unit exhaust openings should
match exhaust openings on rear of microwave oven.
%
Replace the blower plate in the same position
as before with the screws.
_-_ Blower P lateScrews
Blower P late
_J _:j___ Back of Oven
.... J ..... j.s>--
[_ Insert the tabs on each side of the damper
into the holes at the inside rear of the adaptor.
I
--- Exhaust
Adaptor
[_ Attach the exhaust adaptor to the rear of the oven
by sliding it into the guides at the top center of the
back of the oven.
Exhaust A da
Slide exhaust
adaptor into
guideson
ovenrear.
Damper
(hinge sideup)
Screws
Backof Oven
Locking
Tabs Guides
Push in securely until it is in the lower locking tabs.
Take care to assure the damper hinge is installed
so that it is at the top and that the damper swings
freely.
[_ Secure the exhaust adaptor to the oven with
the two bronze metal screws provided.
17