STAMOS TRUE COLOUR GLASS X-100B Manual De Instrucciones página 33

Your local administration will provide you with information about the appropriate
disposal point for used appliances.
Dimensions of protective lenses
Model
COLOR GLASS X-100B
COLOR GLASS X-100
COLOR GLASS XI-100B
COLOR GLASS XI-100
Replacing the front protective lens
1) Gently press down on the center of the latch and slide inward the lock on the
left and right sides, then squeeze to remove the holder.
2) Remove the old protective lens from the holder, insert a new one. Make sure
that the protective film has been removed from the lens.
3) Insert the two tabs into the lower holes in the holder.
Note: Do not use the welding helmet without the protective lens attached.
Replacing the inner protective lens
1) To remove the protective filter lens, pull the top edge.
2) Remove the foil from the new protective lens.
3) Slide one of the side edges of the lens into the holder.
EN
Outer protective lens
[mm]
136x121
139x122
Inner protective lens
[mm]
106x102
106x102