Publicidad
Idiomas disponibles
Idiomas disponibles
SELECTION OF AUDIO/VIDEO
SOURCE
1
00=000
1 Select the program source.
Press one of the FUNCTION buttons or the TAPE MONITOR
button.
Radio
I TUNER
Record
I PHONO
I Television, etc.
I AUXiTVaj
I
I Com~act disc
I CD
I
Video (VCR or LD)
VIDEO 1, VIDEO 2a),VIDEO 3
MD
] VIDEO 2')
a):For selecting AUmV,
or VIDEO 2/LD/M D, see "TOchange
a displayed name for the AUX/TV button and VIDEO 2
button" of "BEFORE OPERATION" (see page 6).
When using a turntable with a built-in equalizer amplifier, set the
switch of the equalizer amplifier to off. See the instructions of
the turntable for further information.
2 Start the selected program source.
3 Adjust the sound.
About
the
video source to
the
monitor or TV
Selected VIDEO source
VI: VIDEO 1, V2: VIDEO 2, V3: VIDEO 3
RECORDING
AN AUDIO SOURCE
1
2
3
1
Select the program source to be recorded.
Press one of the FUNCTION buttons.
Set the tape deck or MD recorder to the recording
mode.
Start the selected program source.
To monitor recorded sound during recording (when the
connected tape deck is a three-head system)
Press the TAPE MONITOR button. "TAPE ON" appears on the
display for four seconds, and then the source name selected in
step 1 comes back on. To cancel the tape monitor, press it again
so that "TAPE oFF appears.
Any sound control except the BBE system has no effect on
recording (see page 7).
The selected video source is indicated on the display and the
video signal through the MONITOR VIDEO OUT jack is output
on the TV.
9
ENGLISH
Publicidad
