Kicker 19434227 Instrucciones página 7

Carefully lay the tailgate cover back into position making sure that no wires are pinched in the process.
Open the lid and tilt the speaker assembly up to connect the speaker wires.
Note: There are two different size connectors. Make sure the large connector is
connected to the large speaker terminal and the small connector is connected
to the small speaker terminal.
Note: Make sure the speaker terminals are properly inserted into connectors. It is
possible for the speaker terminal to be inadvertently inserted between the
metal connector and the plastic insulator.
Wipe the mounting surface of the speaker assembly and the tailgate cover with one of the supplied alcohol
wipes. Apply the supplied double-sided tape to the speaker assembly and peel back about 1/3 of the
double-sided tape backing as shown. Fold the backing out to the side and crease it to get it to stay.
Install the supplied bracket with supplied bolt and washer. Make sure the bracket is oriented correctly as
shown. Next, install the threaded clip with the threaded portion facing down as shown.
Lay the speaker assembly into position making sure no wires are pinched. Thread the suppled torx bolt
into the center hole and the threaded clip until finger tight.
While making sure the speaker assembly is correctly located to the tailgate cover, and while applying a
small amount of downward pressure, pull the double-sided tape backing off the tape on both sides.
Tighten the torx bolt but do not overtighten.
7