Kicker 19434974 Instrucciones página 4

Install the amplifier onto the amplifier bracket with
the supplied screws (short screws x 4). Fig 6
Connect the amplifier harness to the amplifier and
the four-pin connector to the tilt switch attached to
the amplifier bracket. Fig. 7 Route the harness
along the factory harness toward the passenger
side.
Secure the amplifier harness to the bracket with one
of the two supplied retainers. Fig. 7
Note: The tilt switch is designed to turn the
speaker system off when the inner
tailgate is not in the fully down
position. Failure to make this
connection or attempting to bypass this switch will result in a constant drain
on the vehicle battery. Likewise, any cutting, splicing or any other
modifications made to the amplifier harness will immediately void the warranty.
Disconnect the connector pictured and install the light kit T-harness (if equipped). Fig 7
Tilt Switch
Light Kit
Connection
Fig 6
OR
Fig 7
4