Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 10: ADD GASOLINE TO ENGINE
1.
Use only clean, fresh, regular unleaded fuel with a minimum 86 octane rating.
2.
Do not mix oil with fuel.
3.
With the engine off, remove the fuel cap and slowly add fuel to the tank. Do not overfill, allow approximately
¼ inch of space for fuel expansion.
4.
Screw on the fuel cap and wipe away any spilled fuel.
ATTENTION: Please take into account the rules on "Use of combustibles safety" in this manual on
the "Use of combustibles safety" section.
STEP 11: ADD HYDRAULIC OIL
1.
The log splitter needs to be on a flat, level surface before adding the hydraulic oil.
2.
Remove the oil cap from the hydraulic oil tank.
3.
Add approximately 1.37 gallons of hydraulic oil, 10W AW, AW-32, ASLE H-150, ISO 32, Universal Hydraulic
Fluid or Dexron III Transmission Fluid.
4.
Check the hydraulic oil level.
5.
Start the engine and use the control lever to extend and retract the wedge several times to remove air from
the lines.
6.
With the wedge retracted, check hydraulic oil level again and top up if necessary.
65
EN
Publicidad
